WaterRower Be Dynamic Slider Assembly Manual - page 14
14
OPERATION
SETTING THE LEVEL OF THE BASE RAIL
The rear leg of the Slider base frame has an adjustable height system that
compensates for uneven floor surfaces. The Slider needs to be set exactly level for
optimal performance and to prevent the moving frame from rolling more to one
end of the base rail frame than the other.
The two large knobs located at the top of the rear leg are used to adjust the level
of each side of the base rail. Turn the knobs to raise or lower the rear leg until the
base rails are level (indicated by the spirit level located between the knobs).
Make sure the height adjuster knobs on each side are set at the same level as one
another so the weight of the Slider is evenly distributed.
When moving the Slider to a new location, check that the base rail frame is still set
level before using again.
TURN RIGHT
TO LOWER
TURN LEFT
TO RAISE