WaterRower GX Owner's Manual - page 8

13

14

sTep 5

Tighten the footboard to the mono rail by screwing in the clamp bar bolt (I).

Do not tighten all the way.

× 1

I

sTep 6

stand the machine up. Insert 2 of the Back of Footboard Bolts (which were 

removed in step 3) into the footboard bracket and tighten.

Having kept all the bolts loose will allow easier alignment of the bolts and 

rivnut holes in the footboard.

Do not tighten all the way.

sTep 7

Insert the sub bracket bolt (J) through the “u” in the rail sub bracket (L) 

into the rail, to hold the bracket in place for step 8.

× 2

K

sTep 10

Tighten the rail sub bracket bolt (J) (step 7) firmly in place.

sTep 8

screw in the rail sub bracket (L) underneath the footboard using the two 

remaining back of footboard bolts (K). Tighten all the way.

× 1

J

× 2

K

sTep 9

Go back and tighten all the bolts in steps 1, 2, 5, and 6. Also tighten the 

4 bolts on the front of the rower (below forward riser bumpers, see tag). 

Leave the bolts in step 4 and 7 alone.  should you experience any problem 

with aligning the components, loosen all bolts, align and retighten.