WaterRower GX Owner's Manual - page 9
15
16
sTep 11
unwrap the recoil belt from the forward riser bracket, making sure the belt
runs below and around the pulley.
Attach the D ring on the recoil belt to the bungee hook.
sTep 12
Lay the unit flat and remove the tank stopper from between the top and
bottom deck. use the included syphon pump (O) to fill the tank to the level
indicated on the level gauge sticker located on the underside of the tank.
(see next page.)
Do not fill above the 19 level mark.
Insert one purification tablet (P) every six months. Additional purification
tablets are available upon request at:
www.waterrowerservice.com/puritabs
Moisten the tank stopper to assist with replacement.
P
O
1) To pump water, turn the knob clockwise to close valve as shown in figure A
2) Locate water source above (higher than) water destination:
▪
see Figure B for filling tank
▪
see Figure C for emptying tank
3) squeeze pump 4-5 times until water flows
4) Turn knob counter-clockwise to allow air into the pump and end syphon.
The Level Gauge is positioned underneath the
tank; to locate the Level Gauge sticker stand the
machine up and look between the two wooden sub
rails.
Information on the sticker includes the serial
Number, WaterRower contact information and the
Water Level Gauge. The maximum level to fill the
tank is Level 19 - DO NOT fill above this level. The
standard Calibration Level is Level 17. This level
provides enough resistance for all abilities, from
an elite athlete to an elderly or youth user. It is
recommended that all machines in a group class
setting are filled to Level 17, this is to ensure
all users are in the ‘same boat’, and race times
remain accurate and consistent.
hOw TO fIll anD eMpTy The Tank
The level gauge
A
B
C
WaterRower
M A X I M U M L E V E L
C A L I B R A T I O N
L E V E L
19
18
17
16
15
14
560 Metacom Avenue
Warren, RI 02885
1-800-582-2210
www.waterrower.com
LEVEL GAUGE
Recommended Water Level is Level 17