WATT AGE Lite Stik Assembly Manual - page 2
This instruction manual is designed to help you build a straight, great flying airplane. Please read this manual
thoroughly before beginning assembly of your new Lite Stik. Use the parts listing below to identify and separate
all of the parts before beginning assembly.
KIT CONTENTS We have organized the parts as they come out of the box for better identification during
assembly. We recommend that you regroup the parts in the same manner. This will ensure you have all of the
parts required before you begin assembly and will also help you familiarize yourself with each part.
To make your modeling experience totally enjoyable, we recommend that you get experienced, knowledgable help
with assembly and during your first flights. Your local hobby shop has information about flying clubs in your area
whose membership includes qualified instructors. You can also contact the AMA at the address below.
Academy of Model Aeronautics
5151 East Memorial Drive
Muncie, IN. 47302-9252
(800) 435-9262
www.modelaircraft.org
Global guarantees this kit to be free from de-
fects in both material and workmanship, at
the date of purchase. This does not cover
any components parts damaged by use, mis-
use or modification. In no case shall
Global's liability exceed the original cost
of the purchased kit.
In that Global has no control over the final
assembly or material used for final assembly,
no liability shall be assumed for any damage
resulting from the use by the user of the final
user-assembled product. By the act of using
the final user-assembled product, the user ac-
cepts all resulting liability.
Convert inches into millimeters: Inches x 25.4 = MM
1/64”
=
.4mm
1/32”
=
.8mm
1/16”
= 1.6mm
3/32”
= 2.4mm
1/8”
= 3.2mm
5/32”
= 4.0mm
3/16”
=
4.8mm
1/4”
=
6.4mm
3/8”
=
9.5mm
1/2”
= 12.7mm
5/8”
= 15.9mm
3/4”
= 19.0mm
1”
= 25.4mm
2”
= 50.8mm
3”
= 76.2mm
6”
= 152.4mm
12”
= 304.8mm
18”
= 457.2mm
21”
= 533.4mm
24”
= 609.6mm
30”
= 762.0mm
36”
= 914.4mm
METRIC CONVERSION CHART
Kit Contents
2
1) Forward Wing
Mount
2) Rear Wing Mount
3) Rear Servo Mount
4) Battery/Receiver/
Servo Mount
1
2
3
4
1
1
2
2
3
4
4
1) Control Horn
Back Plate
2) Control Horn
3) Pushrod Guide
for Wire Pushrods
4) Wheel Retainer
for Wire Axle
5) Sticker Sheet
(Not Shown
Note: Many parts on
the plastic parts
trees are not used.
1) Wing Halves
(2 pieces)
2) Horizontal
Stabilizer and
Elevator
3) Vertical Stabilizer
and Rudder
1
2
3
4
4) Wing Dowels (two short, two long)
1) Fuselage Stik
2) Wire Pushrods (2)
3) Receiver Mount
4) Mounting Tape (4)
5) Motor/Drive
Assembly& Spinner
6) Propeller
7) Glue
1
2
3
4
5
6
7
1) Factory Shaped Wire Gear
2) Lightweight Wheel Hubs
3) Rubber O-Ring Tires
4) Wire Tail Skid (Not Shown)
5) Rubber Bands (Not Shown)
1
2
3