Wavecom TnP-500 User Manual - page 13
Wavecom Instruments Fully Integrated Test N Print Unit - User Manual
13
Screen
Instruction
When the initial screen in memory mode operation is displayed. A site and user must
be entered before testing can be done. When using the TnT for the first time, < F1
Select Site will be flashing in the top region of the screen.
Adding a Site
Screen
Instruction
From the initial screen, press F1. Don't hold the F key, this will select a different
function.
The TnT can hold up to 16 sites. To scroll through the sites, press enter. 3 sites
will be shown on each screen. Each site corresponds to an "F" key, for example
Site 1 = F1. To edit a site, hold the corresponding "F" key for 2 seconds. If the Site
has a * symbol next to the name then the site name cannot be altered. This site was
uploaded from WinPATS and needs to remain the same.
Using the keypad, enter the name of the site. The Keypad operates in 3 modes-
Alpha, Numeric and Predictive. When an editable screen is entered, there will be
an ALP, NUM or PRE in the top right hand corner of the screen. If you are using a
full size half size keyboard then the 3 modes don't apply. Leave the text on ALP
mode. Once the details have been typed in press enter to return.
Note: Predictive mode will only work if a dictionary has been uploaded from
WinPATS MX. Once a site has been entered, press enter.
Once a site has been entered, the 'F' buttons are used to select the site. For
example to select site 1, F1 would be pressed.
Once a site has been selected, the TnT will return to the initial screen and the site
that was selected will be shown in the top left hand corner of the screen.
Adding a User
Screen
Instruction
From the initial screen, press F2. Don't hold the F key, this will select a different
function.
The TnT can hold up to 6 users. To scroll through the users, press enter. 3 sites
will be shown on each screen. Each site corresponds to an "F" key, for example
User 1 = F1. To edit a user, hold the corresponding "F" key for 2 seconds.
Entering a user is the same process as entering a site, please refer to the Adding a
Site steps above, Note: The user name will not appear on the initial screen once
selected.