Wavecom TnP-500 User Manual - page 41
Wavecom Instruments Fully Integrated Test N Print Unit - User Manual
41
Dump mode
Printer will enter dump mode after printing printer configuration. In the dump mode, all characters will be printed in 2
columns as following. The left side characters are received from your system and right side data are the corresponding
hexadecimal value of the characters. It allows users or engineers to verify and debug the program.
Note:
1. Dump mode requires 2” wide paper
width.
2. Turn off / on the power to resume
printer for normal printing.
3. Press FEED button to back to the
previous menu.
Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber blinks.
(Any green will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks) amber (5 blinks) green (5 blinks) green/amber (5 blinks) red/amber (5 blinks)
solid green
Printer configuration will be restored to defaults as below after initialization.
Parameter
Default setting
Speed
127 mm/sec (5 ips) (203DPI)
76.2 mm/sec (3 ips) (300DPI)
Density
8
Label Width
2” (50.8 mm)
Label Height
2” (50.8 mm)
Sensor Type
Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset
0
Tear Mode
On
Peel off Mode
Off
Cutter Mode
Off
Serial Port Settings
9600 bps, none parity, 8 data bits, 1 stop bit
Code Page
850
Country Code
001
Clear Flash Memory
No
IP Address
DHCP