Wavecom TnP-500 User Manual - page 14
Wavecom Instruments Fully Integrated Test N Print Unit - User Manual
14
Once a user has been entered, the 'F' buttons are used to select the user. For
example, to select user 1, F1 would be pressed.
Auto Generate Barcode Function
If required, the auto generate barcode number can be set before testing. The auto generate is always displayed in
the bottom left hand corner of the new barcode screen.
Screen
Instruction
The TnT incorporates an auto generate barcode function which allows barcodes to
be generated sequentially after a barcode has been specified, for example: the
specified barcode is 1000 so the next barcode to be generated will be 1001, 1002,
1003 etc. This can be accessed by holding F3 for 2 seconds on the Barcode Entry
screen.
Once the auto generate menu has been accessed, the user can specify how many
digits they want in the barcode. The auto generate function allows a minimum of 2
and a maximum of 7 digits in the barcode to be generated. To increase the number
of digits in the barcode, press F1. To decrease the number of digits in the barcode,
press F2. To proceed, press enter, or to return to the Barcode Entry screen, press
F3.
If enter was pressed, the user can now set the barcode that will begin the
sequence. Key in a barcode and press enter to continue, or F3 to return the Barcode
Entry screen.
If enter was pressed, the user can specify whether or not to use leading zeros in the
auto generated barcode. For example: If the user selected 7 digits in the barcode and
entered 1000 as the barcode, the barcode will be 0001000 if leading zeros are
enabled. To enable leading zeros, press F3. To disable, press enter. The current
barcode that will be generated is displayed in the bottom left hand corner of the
Barcode Entry screen.
The current barcode that will be generated is displayed in the bottom left hand corner
of the Barcode Entry screen.
Entering Items
Screen
Instruction
Type in the new barcode or press F3 quickly to choose the auto generate number.
Once a barcode has been specified, items can be entered. If the screen displays
"search barcode" press enter to switch to new barcode. There must be no numbers
entered in to switch between the two modes.