Wavetronix smartsensor advance User Manual - Beam Alignment Tool

CHAPTER 11  • TOOLS  113

The following window will pop up asking you to confirm that you want to restore the sensor 

to factory defaults:

Figure 11.7 – Restore to Factory Defaults

The process should take only a few seconds. If it is successful you will see a success message. 

Otherwise, you will see a failure message.

Figure 11.8 – Restore Defaults Results

Beam Alignment Tool

Click the Beam Alignment icon to start the Beam Alignment tool (see Figure 11.9). This 

tool is used to help the person installing the sensor to visualize the invisible radar beam 

footprint, based on the sensor mounting offset and mounting height.

By default, the values in the recommended alignment table (see Appendix D and Table 

D.1) are now entered automatically when the Alignment Tool screen first appears. The 

alignment tool values will be correct only if you have correctly put height and offset infor-

mation in the 1. Installation Details screen.

Figure 11.9 – Beam Alignment Tool