WeatherTRAK ET Pro3 Getting Started Manual - Wall Installation
WeatherTRAK ET Pro3 Installation Instructions
©2013HydroPointDataSystems,Inc.Allrightsreserved.WTETP3II0513
6
800.362.8774 • hydropoint.com
Station Keys
TheWeatherTRAKETPro3incorporatesstationcountmodularityby
usingstationkeys.Thestationinput/outputboardsareavailable
intwoconfigurations,uptoeither12to24stationsor12to48sta-
tions.Toincreasethestationcountfrom12to18stationsorhigher,
insertastationkeyintothestationoutputboardfromlefttoright
(seeFigure6).Thestationkeywillilluminatewhenactivated.The
controllerwillautomaticallydiscovertheexpandedstationcount
within30seconds.
Figure 6
Station Keys
Toprogramadditionalstations:
•
Increase“MaxActiveStations”intheSETUPmenu.Additional
stationscanbeprogrammedfromthecontrollerorremotelyvia
www.weathertrak.net.
•
Toincreasetheoverallnumberofstationsabove24,addan
additionalstationexpansionboardwiththecorrespondingsta-
tionkeys.ContactHydroPointoryourlocaldistributorforthis
servicekit.
Controller Electrical Specifications
•
TransformerSize:3.0amp,80VA,ULlisted
•
InputPower:120VAC(60Hz)or220VAC(60Hz)
•
StationOutputSpecifications:
• 24VAC(60Hz)
• 1.0amps(1000milliamps)max.perstationoutput/pump
output
• 1.0amps(1.0milliamps)maxmastervalveoutput
• 3.0ampsmaximumallowableload
Wall Installation
Note:AvoidpotentialelectricshockbyconfirmingtheAC
poweris“off”beforestartingthiswork.
Wall Mounting Instructions
Locatethe2mountingholesonthebackoftheenclosure.Thetwo
uppermountingholesarekeyholes.Thisdesignallowsthetwo
upperfastenerstobeinstalledfirst.Theenclosureisthenslipped
overandpusheddowntocompletetheinstallation(seeFigure7).
Usetheenclosedblue-coloredpapertemplatetolocatetheseholes
accurately.Typicalmountingheightforawall-mountenclosureis
between41”and48”aboveafinishedsurface.
Figure 7
Example of Wall Mount Drilling Template
Athirdmountingholecanbefoundinthecenteroftheenclosure
belowthestationinput/outputboard.
Beforedrilling,verifythatthecontrollerislevelandvertically
straightbeforeinstalling.
Step 1. Removetheouterdoortogainbetteraccesstotheinterior
oftheenclosurebyslidingitupwards,thenplaceitina
location to prevent damage.
Step 2. Markanddrillnewmountingholesusingtheblue-colored
papertemplate,thendrillappropriatelysizedholeswitha
hammer-drillasneeded.Useplasticinsertsandmounting
screws(tapedtothecontrollerwiththeenclosurekeys)to
securethecontroller.
Step 3. Hangtheenclosureonthesefastenersandverifytheen-
closureismountedlevelbothverticallyandhorizontally.
Step4. Locatethethirdcentermountingholeandinsertthelast
fastener.Tightenallfastenerstotheenclosuretosecureto
theverticalsurface.