WEG SSW-08 User Manual - page 16
3
Installation and Connection
SSW-08 | 11
3.1.3.2 Mounting on Surface
Figure 3.3 shows the installation of the Soft-Starter SSW-08 on the surface of a mounting plate.
Figure 3.3: Installation procedures of the Soft-Starter SSW-08 on a surface
3.2 ELECTRICAL INSTALLATION
DANGER!
The Soft-Starter SSW-08 cannot be used as an emergency stop device.
Always use an isolation contactor or a circuit breaker to disconnect the power supply
of the SSW-08.
DANGER!
Be sure that the AC input power is disconnected before making any terminal
connection.
ATTENTION!
The information below may be used as a guide to achieve a proper installation. Follow
also the applicable local standards for electrical installations.
ATTENTION!
If a power isolating contactor or circuit breaker with minimum voltage coil is not used
at the first power on, then power up the electronics first, adjust the trimpots that are
necessary to put the SSW-08 into operation and only after this energize the power
section.