Weider 9150 User Manual - page 10
15
33. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on page 20 for proper cable routing. If there is any slack in the cables, you will need to
remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on page 19.
32. Attach the Curl Pad (24) to the Curl Post (35) with
two M6 x 16mm Screws (18).
32
24
35
18
10
12. Wrap the High Cable (23) around a “V”-Pulley (6).
Attach the Pulley and a Long Cable Trap (50) to
the bracket on the Top Frame (55) with an M10 x
60mm Bolt (7) and an M10 Nylon Locknut (21).
Be sure the Cable Trap is oriented to hold the
Cable in the groove of the Pulley.
14. Wrap the High Cable (23) around a 90mm Pulley
(15). Attach the Pulley to the Pulley Bracket (20)
with an M10 x 45mm Bolt (88) and an M10 Nylon
Locknut (21).
Attach the Pulley Bracket (20) to the Top Frame
(55) with an M10 Washer (9) and an M10 Nylon
Locknut (21).
13. Wrap the High Cable (23) around a “V”-Pulley (6).
Attach the Pulley and a Long Cable Trap (50) to
the Left Butterfly Arm (47) with an M10 x 60mm
Bolt (7) and an M10 Nylon Locknut (21). Be sure
the Cable Trap is oriented to hold the Cable in
the groove of the Pulley.
Repeat this step with the Right Butterfly Arm
(48).
12
55
23
7
50
21
6
13
14
7
6
50
21
23
47
48
20
21
88
21
9
15
23
55
15. Wrap the High Cable (23) around a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the second set of holes from the
top of the two Pulley Plates (58) with an M10 x
52mm Bolt (12) and an M10 Nylon Locknut (21).
Be sure the small tabs on the Pulley Covers
are on top.
15
21
58
12
40
40
15
23
Small
Tabs
58
31. Attach the Seat Frame (36) to the Front Upright
(42) with the M10 x 80mm Carriage Bolt (11) and
the Seat Knob (49).
31
49
42
36
11