Summary of Aspen X
Page 1
Aspen x assembly manual.
Page 2
Warning: two people are required when lifting/moving the carton. Introduction: congratulations on your purchase of a woosh electric cycle. Your woosh electric cycle comes mostly assembled, but ob- viously to enable the cycle to be flat-packed, some parts of the cycle require a small amount of assemb...
Page 3
Step 1 – opening the carton. Keep the carton upright, remove the shipping straps and cut the tape seals. Remove the wheel from the carton, being careful not scratch the bike as you do this. Now lift the bike out of the carton and lean it against a sturdy surface/wall. Do not destroy the carton as it...
Page 4
Step 3 – front wheel lift the front of the bike slightly and remove the protective plastic from the front forks. Place front of bike gently back down. Fetch the front wheel and loosen off the fixings on either side if necessary to allow the wheel to be fitted. You may wish to turn the bike upside do...
Page 5
Step 4 – front brakes fit the curved metal section into the receptacle on the left of the brake assembly. You may need to loosen the cable clamp on the right side of the brake assembly to do this. Re-tighten the brake cable clamp ensuring the correct ten- sion and the correct position of the brake-p...
Page 6
Step 5 – saddle the saddle is already fitted, but to adjust the height of the saddle, open the clamp and position the saddle at the de- sired height and then close the clamp to lock the saddle into position. It may be necessary to tighten the thumb screw a little to ensure that when the clamp is clo...
Page 7
Step 6 - pedals the pedals are designed to fit on a specific side of the bike, do not attempt to fit the pedals without first checking which side of the bike the pedal is meant for. To identify which pedal goes on which side. The ‘r’ and ‘l’ indicates which side of the bike the pedal should be fitte...
Page 8
Step 8 – front mudguard remove the packaging from the mudguard if you haven’t already done so. Remove the nut from the bolt just behind the front brake as- sembly, this also secures the light, so be careful not to let the light fall. The metal tag of the mudguard needs to be fitted between the front...
Page 9
You will need to hold the light in place at the same time as securing the top section of the mudguard. For the best clearance between the tyre and mudguard, when securing the tag at the top of the mudguard, it should be at it’s highest position. It may be useful to wedge some- thing between the tyre...
Page 10
Charging the battery: to recharge the battery, lift the handle on the battery at the rear of the bike, attach the charger to the socket on the right side of the battery as shown below. Plug the other end into the mains. The battery does not have to be removed from the bike to be charged, but it can ...
Page 11
Essential extra steps that must be taken before riding the bike (and also regularly thereafter): all items on the bike should be double checked to ensure that all parts are correctly fitted and that all the nuts and bolts are as tight as they should be. This step should be repeated after one week of...
Page 12
© 2012 woosh bikes limited.