Woosh Aspen X Assembly Manual - page 3
Step 1 – Opening the carton.
Keep the carton upright, remove the shipping straps and cut
the tape seals. Remove the wheel from the carton, being
careful not scratch the bike as you do this. Now lift the bike
out of the carton and lean it against a sturdy surface/wall. Do
not destroy the carton as it will be required if the bike needs
to be returned for any reason in the future.
Step 2 – Unpacking
Cut the cable ties and detach the pedals, handlebars and
charger etc. from the bike, and then remove the remaining
packaging materials.
Once the packaging has been removed, undo the bolts that
hold the handle-bar clamp in place and remove the clamp.
Line up the handle-bars and then replace the clamp to se-
cure the handle-bars in place. There is a ribbed section on
the handle-bars, this should sit centrally within the bracket.