Woosh Aspen X Assembly Manual - page 4
of
12
Step 3 – Front Wheel
Lift the front of the bike slightly and remove the protective
plastic from the front forks. Place front of bike gently back
down.
Fetch the front wheel and loosen off the fixings on either side
if necessary to allow the wheel to be fitted. You may wish to
turn the bike upside down to fit the wheel, but if you aren’t
able to, follow the steps below.
Lift the front of the bike holding the bike frame and then care-
fully lower the bike onto the wheel ensuring that the wheel is
seated in the correct position.
Finger tighten the nuts/clamp on either side of the wheel so
that when the clamp is engaged, the wheel is fully secured
You can now use the ‘bike stand’ to keep the bike upright.