Woosh Aspen X Assembly Manual - page 5
Step 4 – Front Brakes
Fit the curved metal section into the receptacle on the left of
the brake assembly. You may need to loosen the cable
clamp on the right side of the brake assembly to do this.
Re-tighten the brake cable clamp ensuring the correct ten-
sion and the correct position of the brake-pads with relation
to the wheel rim. You may need to adjust the position of the
brake pads, use the supplied Allen key to do this. For a guide
on adjusting your brakes, see the support section of our web-
site at www.wooshbikes.co.uk
Now is a good time to release the front suspension which is
locked for transit purposes, this is done by twisting the cap
above the right fork. Failure to observe this step will result in
an uncomfortable ride and excessive rattling of the bike.