Worx WG303E Safety And Operating Manual - Chain Saw
12
Chain Saw
WG303E
Intended use
The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts can
be sawed with or across the grain. This product is not
suitable for sawing mineral materials.
ASSEMBLY
WARNING! Do not connect the chain saw to
mains before it is completely assembled.
Always use gloves when handling the chain.
CHAIN AND GUIDE BAR ASSEMBLY
1. Unpack all parts carefully.
2. Place the chain saw on a solid, level surface.
3. Use only genuine WORX chains designed for
chainbar.
4. Slide the chain (8) in the slot around the chain bar
(7). Ensure chain is in correct running direction by
comparing with chain symbol (14). Ensure the chain
tensioning catch (18) is facing outwards. (See Fig. A)
5. Fit the chain onto the drive sprocket (13) and guide
the chain bar (7), so that the fastening bolt (17) and
the two guide fins (15) fit into the keyway of the chain
bar(7). (See Fig. B)
6. Check if all parts are seated properly and hold chain
and chain bar in a level position. (See Fig. C1)
7. Fit cover plate, ensure that the chain catcher (20) fits
into the groove of the cover plate(11). (See Fig. C2)
8. Screw on the cover plate (11) with the locking knob
(10). (See Fig. D)
The chain is not yet tensioned. Tensioning the chain
applies as described under “Tensioning chain”.
11
20
18
7
8
17
15
14
13
A
B
C1
C2