Worx WG303E Safety And Operating Manual - Chain Saw
14
Chain Saw
WG303E
4. Avoid dirt or debris entering oil tank, refit oil filler cap
(4) and tighten.
IMPORTANT: To allow venting of the oil
reservoir, small breather channels are
provided between the oil filler cap and the
strainer, to prevent leakage ensure machine
is left in a horizontal position (oil filler cap (4)
uppermost) when not in use.
It is important to use only the recommended oil
to avoid damage to the chain saw. Never use
recycled/old oil. Use of non approved oil will
invalidate the warranty.
OPERATION
1. SWITCHING ON AND OFF (See Fig. F)
ATTENTION: Check the voltage and current
supply: The voltage and current supply must
comply with the ratings on the type plate.
For switching on the machine, press the lock-off (3)
button, then fully press the on/off switch (2) and hold in
this position. The lock-off button (3) can now be released.
For switching off, release the on/off switch (2).
Do not stop chain saw after sawing by activating the
front hand guard (chain brake).
2. CHAIN BRAKE (SEE FIG. G)
The chain brake is a safety mechanism activated
through the front hand guard (5), when kickback occurs.
Chain stops immediately.
The following function check should be carried out at
regular intervals. Push front hand guard (5) forwards
(position ) and start the chain saw. The chain must not
start. To deactivate the kickback brake, pull hand guard
(5) backwards (position ). and
release On/Off switch (2)
F
G
1
1
2
5