XENO XDR960 User Manual - page 24
User’s Manual | 24
User can automatically switch PTZ camera positions according to defined presets by using the GUARD TOUR function. The
connected PTZ camera must support touring functions. “GUARD TOUR” on the pop-up menu can be enabled only in full
screen mode. See 4.2.6 PTZ for instructions on how to setup the GUARD TOUR.
3.5 Call Monitor Operation
Click the right button on the mouse and select the CALL MONITOR in order to enter call monitor control mode. The numeric
panel will pop up at the center of the screen.
Click the specific channel button on the numeric panel to display full screen mode out of assigned spot out channels.
▪ Press the close button on the bottom of the numeric panel. It will go back to the previously programmed spot monitor mode.
N
OTE
- A spot out monitor displays another spot out monitor
’s video in full screen through the function, call
monitor.
- In spot sequence setting mode, if Call monitor is selected, spot sequence stops and selected channel
pops up.
- While call monitor runs, if a channel event happens, Call monitor stops and the event pops up.
C
AUTION
Depending on PTZ camera, some preset positions might be skipped if, for example, the PTZ camera
cannot mechanically move or control focus within the interval time required by the DVR. In this case, it
is recommended to increase the interval setting to a value that allows for the cameras to finish its Pan
& Tilt.