XENO XDR960 User Manual - page 36
User’s Manual | 36
-
NTP Setup- Setup the DVR to automatically sync with a Network Time Protocol.
There are two types of TIME SYNC MODE:
o
Server Mode- The DVR is set as a Time Sync
Server, which can synchronize its own time with
another DVR(s) connected over the same
network environment.
o
Client Mode- The operating DVR is set as the
client DVR. Enter the IP address or URL of
another DVR, Advanced Client Software (ACS),
or Central Management System (CMS), as a
Time Sync Server in “SYNC SERVER”. This will
cause your DVR to sync its time with a Time
Sync Server in the set interval time.
-
Display Options- Set sequence dwell time, spot-out dwell time, spot-out channel, pop-up camera, and OSD as
indicated below:
o
OSD:
Select which information will be displayed in the OSD visible on each channel in Live.
Select which information will be displayed in the OSD visible on each channel in Playback.
Set the OSD’s transparency level, the higher the percentage, the more transparent the OSD text
will appear.
Setup a dwell time for the OSD text, after which, the OSD will automatically disappear.
Setup a dwell time for the Setup Menu, after which, the Setup Menu will automatically disappear.
o
Set sequence dwell time- Setup how long the system will display each channel in Sequence mode, before
switching to the next channel.
o
Spot-out Monitor Spot monitor operation
1. Spot out display mode - It supports programmable multi display mode(Full,4,9,16) on digital spot output.
2. Spot out channel select- Spot out monitor displays selected channels only or spot sequence displays.
** Non-selected channels are not displayed as black screen in covert
3. Spot out cam popup- If cam popup is set in Sensor, Motion notify, Spot monitor also pops up the event.
4. Spot Monitor interval- Spot Sequence time setting
o
You may select On/Off for Live or Playback status display by checking a check box.
-
Screen Saver Setup- See section 3.13 Screen Saver for more information.
-