Xerox Color J75 Press User Manual - page 212
3. Lift the green handle and/or rotate the green knob and remove all paper in the
entrance area.
4. Close the green handle(s).
5. Close the HCS Front Cover.
6. If the UI indicates there is a jam in the print engine, follow the instructions on the
screen to remove any paper in the area indicates.
7. Follow the instructions displayed on the UI to resume printing.
Hints and tips for using the HCS
Refer to the following hints and tips when using the HCS:
1.
Check the paper in the Stock Tray for curl.
a) If no curl is present and if the output is acceptable (meets customer satisfaction),
you are finished.
b) If no curl is present and if the output is NOT acceptable, call for service.
c) If curl IS present, continue to the next step.
2.
Check the paper in the Stock Tray for curl.
3.
Adjust the paper curl by using the decurler controls on the top of the Interface
Module.
4.
If the output has not improved, adjust the paper curl again.
5.
If the output still has not improved, call the Customer Support Center.
Loss of power
If power is interrupted to the HCS:
• Ensure the power cord is plugged in to the proper wall receptacle
• Ensure that the machine power is switched “On”
• Ensure that the Ground Fault Indicator is in the “On” position
• If the power has not been restored by checking the above items, then call for service
Xerox
®
Color J75 Press
14-10
User Guide
High Capacity Stacker (HCS)