Xerox DocuColor 7000 Operator's Manual - page 104
DocuColor 8000/7000 Operator Manual
3-30
3. Accessories
Using the HCSS80
Use the HCSS80 by sending a document through the network and
making your selections under Job Properties/Parameters. If you
are sending a job through the network, refer to the manuals that
came with your color server for information on how to set the job
Properties/Parameters when using the HCSS80.
Hints and tips
•
The HCSS80 cannot staple jobs with mixed sizes of paper.
•
The stacking may be skewed on the output from mixed size
paper jobs.
•
You can use mix-coated and uncoated stock.
•
The HCSS80 accepts jobs of mixed weight papers below 59
lb. (220 g/m
2
).
•
Only clear paper jams at the area indicated on the HCSS80
Control Panel. Do not remove paper from any other areas of
the paper path.
Stapling Hints
There are three stapling options:
•
Single Staple Position 1:
The HCSS80 places a staple in the
upper left corner of SEF or LEF sets.
•
Single Staple Position 2:
The HCSS80 places a staple in the
bottom left corner of SEF sets only.
•
Dual Staple: The HCSS80 places two staples closer to the
top/bottom center of the sheets than a single staple.
All three of these positions are illustrated in the Staple Positions
table on page 3-32.