Xerox DocuColor 7000 Operator's Manual - page 65

DocuColor 8000/7000 Operator Manual

2-9

2. Paper and paper trays

Tabbed inserts

Tabbed Inserts can be loaded into the paper trays as Non-

Standard paper.  

•

When loading, the non-tabbed, short edge of the tabbed insert 

should be the lead edge to the digital press. 

•

If a jam occurs while running tabbed sets, there is no recovery 

procedure. 

•

You have to manually reassemble your originals and 

prints, determine where the job left off, and resume printing 

or cancel the job and start again.

•

The size of the tabbed insert should be 9 x 11 inch (229 x 279 

mm) for letter size tabs (223.5 x 296 mm for A4 equivalent 

tabs). 

•

The correct weight of the insert should be selected on the 

tray. 

•

Select Non-Standard size on the paper tray and on the UI, 

Tools Mode, input 11 inches or 296 mm for A4 as the X axis 

and 9 inches or 223.5 mm for A4 as the Y axis dimensions for 

SEF. 

Refer to the System Administration Guide for the procedure to 

program non-standard size paper.