Xerox DocuColor 8000 Supplementary Manual - page 36

C

ALIBRATION

36

If you deselect Apply to all calibration sets, you can choose to apply the current calibration to 

a selected subset of the calibration sets on the server. To specify which sets, click Customize, 

which opens the Apply To dialog box. 

Select or clear individual calibration sets, and then click OK.

If any of the selected calibration sets are not associated with an output profile, a warning 

appears, but you can choose to apply the calibration measurements to that set anyway.

The calibration measurements are copied to the specified calibration sets at the end of the 

calibration process when you click Apply.

Restoring default calibration measurements

Use the following procedure to return to factory default calibration measurements.

T

O

RESTORE

DEFAULT

CALIBRATION

MEASUREMENTS

1 In the Calibrator dialog box, click Restore Device.

2 Click OK to restore the preset default calibration set.

N

OTE

: 

If the Apply to all calibration sets option is selected, all calibration sets on the server are 

restored. If Apply to all calibration sets is cleared, Restore Device applies only to the 

calibration sets selected under Customize.