Xerox DocuColor 8000 Supplementary Manual - page 40
Other manuals for DocuColor 8000:
Use Manual, Planning Manual, Operator's Manual, Reference Manual, Getting Started, Brochure, Manual, Operating Instructions, Software Installation Manual, Supplementary Manual, Reference Manual, Supplementary Manual
Manual is about: Xerox Printer Operator Manual
of
98
C
ALIBRATION
40
8 Click Measure.
9 If necessary, choose the appropriate COM port for the DTP41 from the Available Ports menu,
and then click Start Measurements.
10 Feed the measurement page into the DTP41, starting with the cyan strip.
Align the page in the measurement page slot of the DTP41 so that the appropriate color
column is centered below the alignment mark. Insert the page about three inches, past the
front idler rollers, until it rests against the rear drive rollers and you feel resistance.
11 Click Read Strip.
The DTP41 pulls the measurement page through automatically.
After the measurement page is read, Calibrator instructs you to insert and align the page again
for the next color.