Xerox Versant 80 Press System Administration Manual - page 56
21. Select the tray in which you loaded paper in step 1, and then press the Start button.
22. Select the adjusted fold position type, and select Save.
23. Continue to select Save or Close until you are returned to the main Tools tab display.
24. Exit the administrator mode.
Adjusting the Booklet Fold Position
1. Load paper in the desired tray.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings .
6. Select Maintenance > Finisher Adjustment
7. Select Adjust Fold Position.
8. Select Fold Position Type Setup, and select Change Settings.
9. Select Booklet and select Change Settings.
10. Press Sample Printout.
11. Select the tray in which you loaded paper, select 2-Sheet Stack, and press the Start
button.
An output sample is printed.
12. Select the tray in which you loaded paper, select 15-Sheet Stack, and press the Start
button.
An output sample is printed.
13. Select Close.
14. Check the output sample, and measure the position offset amount for 2-sheet stack
and 15-sheet stack.
15. Press Booklet Fold State (2 Sheets).
16. Select the state of the fold and staple position of the output paper, and enter the
2-sheet stack offset amount you measured in previously in Values A & B Before
Adjustment field.
17. Select Save.
18. Set Booklet Fold State (15 Sheets) in the same way.
Note
The values between 2-sheet stack and 15-sheet stack are adjusted automatically.
Note
When you want to specify the number of sheets separately, use the set Variable-Sheet
Booklet option to make the proper selections.
19. Press Sample Printout again to print an output sample, and check the adjustment
results.
20. Make adjustments again if necessary.
21. Select Save.
22. Select Close until the Adjust Fold Position screen appears.
23. Select the tray in which you loaded paper in step 1, and then press the Start button.
24. Select the adjusted fold position type, and select Save.
Xerox
®
Versant
®
80 Press
4-26
System Administration Guide
System Settings (Tools Administrator Mode)