Xerox Versant 80 Press System Administration Manual - page 64
Offset Stacking (Stacker - Stacker Cart)
This feature is available only when the High Capacity Stacker (HCS) is connected to
the machine. Offsetting means that each copy set is delivered to the center tray and
shifted slightly to separate it from the previous job. When a copy set is delivered to the
front of the tray, the next set is delivered to the rear of the tray. Options for the offset
function for the High Capacity Stacker include the following:
• None: If this option is selected, the finishing tray will not offset any output.
• Offset per set: If this option is selected, the finishing tray will offset each set of a
copy/print job. This option also offsets each job.
• Offset per job: If this option is selected, all the sets of a job are delivered on one
stack to the output area. When the next job starts, that job is offset from the previous
job in the tray. This option does not offset each set of a job.
When Offset per Set or Offset per Job is selected, the machine slightly shifts the output
position per set or per job (print job) respectively.
Unload High Capacity Stacker
This feature is available only when the High Capacity Stacker (HCS) is connected to
the machine. Allows you to determine the timing to stop the machine when the Unload
Output button is pressed. Select either Stop When Current Set Completes and Stop
Immediately.
Auto Job Promotion
This Other Settings option allows you set the machine to automatically promote a job
for printing/copying if the machine is unable to start a prior job. For example, the
machine is unable to start an operation because there is no paper in the tray (at the
start of a copy or print operation). If this feature is enabled, then the machine can
bypass the current job and allows other jobs to start.
Tip
The other jobs must not have the same copy/print requirements as the faulted job. If
other jobs have different copy/print requirements, then these other jobs can be
promoted and copied/printed.
Note
Stored documents such as secure prints and sample prints are excluded and cannot be
automatically promoted.
Default Print Paper Size
Set the default paper size, A4 or 8.5 × 11 in. on which to print reports and/or lists.
Xerox
®
Versant
®
80 Press
4-34
System Administration Guide
System Settings (Tools Administrator Mode)