Xerox WorkCentre 3025BI User Manual - page 226
Electrical Safety
Xerox® WorkCentre® 3025
User Guide
216
Electrical Safety
General Guidelines
WARNING:
Unauthorized alterations, which may include the addition of new functions or
connection of external machines, may impact the machine certification. Please contact your
Xerox representative for more information.
•
Do not push objects into slots or openings on the printer. Touching a voltage point or shorting
out a part could result in fire or electric shock.
•
Do not remove the covers or guards that are fastened with screws unless you are installing
optional equipment and are instructed to do so. Turn off the printer when performing these
installations. Disconnect the power cord when removing covers and guards for installing
optional equipment. Except for user-installable options, there are no parts that you can
maintain or service behind these covers.
The following are hazards to your safety:
•
The power cord is damaged or frayed.
•
Liquid is spilled into the printer.
•
The printer is exposed to water.
•
The printer emits smoke, or the surface is unusually hot.
•
The printer emits unusual noise or odors.
•
The printer causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1.
Turn off the printer immediately.
2.
Disconnect the power cord from the electrical outlet.
3.
Call an authorized service representative.
Power Cord
Use the power cord supplied with your printer.
•
Plug the power cord directly into a properly grounded electrical outlet. Ensure that each end of the
cord is connected securely. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
WARNING:
To avoid risk of fire or electrical shock, do not use extension cords, power strips, or
power plugs for more than 90 days. When a permanent outlet receptacle cannot be installed, use
only one factory-assembled extension cord of the appropriate gauge per printer or multifunction
printer. Always adhere to national and local building, fire, and electrical codes regarding length of
cord, conductor size, grounding, and protection.
•
Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.