Xexun Tk 102-2 User Manual - page 10
10
5.11.2 Cancel: Send SMS nostockade+password to deactivate this function.
5.11.3 Response SMS format: stockade!+geo-info to the authorized numbers. It will alarm
one time in each setting.
5.12 Movement Alert
This function is using for the owner to get alarm when the tracker moves out of a
restricted district.
5.12.1 Set up: Send SMS move+password to the unit to set the movement alert.then the
unit will reply “move ok!”. In case of such a movement, it will send SMS “Move” along with
a Geo-info to the authorized numbers. It will alarm one time in each setting.
5.12.2 Cancel: Send SMS nomove+password to deactivate the movement alert.
Remark: This function will be out of effect after the unit moves outside the district.
Response SMS format: move!+geo-info. It will alarm one time in each setting.
5.13 Overspeed Alert:
This function is using for the owner to control the target’s speed.
5.13.1 Set up: Send SMS speed+password+space+080 to the unit (suppose the speed is
80km/h), and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the unit
will send SMS speed+080!+Geo-info to the authorized numbers. It will keep sending such
an alert every 3 minutes.
5.13.2 Cancel: Send SMS nospeed+password to deactivate the overspeed alert
Remark: It is recommended that the speed alarm is set at not less than 50km/h. For
below that rate, it may cause the excursion of the GPS signal influenced by clounds etc.
Response SMS format: speed+080!+Geo-info (suppose the speed is 80km/h).
The tracker will check the speed in 10 minutes interval and alarm if it is overspeed.
WWW.GPS-TEKNIK.SE
WWW.GPS-TEKNIK.EU
DEVELOPER@GPS-TEKNIK.SE
FORUM - WWW.GPS-TEKNIK.EU