Xexun Tk 102-2 User Manual - page 6
6
5.3 Startup
z Put the SIM card and battery in place.
z The unit turns on automatically when the sim card and battery is inserted.
z For the first use, please initialize the unit and restore it to default setting.( please refer
to 5.4 for instruction.)
z In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well
as the GPS signals. The indicator will keep flashing every 4 seconds when the unit
has received the signals, otherwise it will keep on.
z When this unit receives GPS signals normally, you can use it and do all the following
settings.
5.4 Initialization
Send “begin+password” in SMS to the unit, it will reply “begin ok” and initialize all the
settings. (default password: 123456)
5.5 Change the Password
Send SMS password+old password+space+new password to change the password.
Remark:
5.5.1 Be sure keep the new password in mind, you have to upload the software to restore
the original setting in case of losing the new password.
5.5.2 Make sure the new password is in 6 digits, or else the tracker can not recognize the
password.
5.6 Authorization
There are only 5 numbers able to be authorized.
5.6.1 Setup: Send SMS admin+password+space+cell phone number to set up a
authorized number. The other authorized numbers should be set by the first authorized
WWW.GPS-TEKNIK.SE
WWW.GPS-TEKNIK.EU
DEVELOPER@GPS-TEKNIK.SE
FORUM - WWW.GPS-TEKNIK.EU