Xexun Tk 102-2 User Manual - page 12
12
5.19 GSM ID(this function can be add or delect for customization.)
There is GSM ID in each SMS from the tracker. The location of the tracker can be found
according to the GSM ID in case of no GPS signal. GSM ID is make up of MCC(Mobile
Country Code),MNC(Mobile Network Code),LAC(Location area code) and Cell ID.(refer
to 5.6.5)
5.20 Motion Sensor(this function can be add or delect for customization.)
This function is using for the user to get alarm info when someone touchs the unit.
5.20.1 Setup: Send shake+password+space+1-10 to the tracker to set up this
function.(1-10 means the level of intensity)
5.20.2 Send SMS shake+password+space+1 is the lightest level of intensity.the tracker
will send alert if someone touchs the unit heavily.
5.20.3 Send SMS shake+password+space+10 is the strongest level of intensity.the
tracker will send alert if someone touchs the unit slightly.
5.20.4 Cancel: Send SMS shake+password+space+0 to remove this function.
5.21 SD card function
A mini SD card can be put in the tracker’s SD card slot. The GPRS data can be saved in
the SD card if GPRS is off. It will send data to the GPRS server again if GPRS is on.
5.21.1 Setup: Send SMS sdlog123456 1 to the tracker to activate the function of storing
data in SD card;
Cancel: Send SMS sdlog+password+0 to the tracker to deactivate the function of
storing data in SD card.
5.21.2 Setup: Send SMS readsd+password+space+1 to ask the tracker to send data in
the SD card to the GPRS server.
WWW.GPS-TEKNIK.SE
WWW.GPS-TEKNIK.EU
DEVELOPER@GPS-TEKNIK.SE
FORUM - WWW.GPS-TEKNIK.EU