Xexun TK-102 User Manual - page 9
restricted district. In case of breach, it will send SMS “stockade!+geo-info” to the authorized
numbers.
Remark : The first latitude&longitude is coordinate of the top left corner of the Geo-fence,
while the second latitude&longitude is the coordinate of the bottom right corner. It will alarm
one time in each setting.
5.11.2 Cancel: Send SMS nostockade+password to deactivate this function.
This function will be out of effect after the unit moves outside the district.
5.12 Movement alert
5.12.1 Set up: When the unit stays immobile in a place for 3-10 minutes, the user can send SMS
move+password to the unit, then the unit will reply “move ok!”. In case of such a movement, it
will send SMS “Move” along with a Geo-info to the authorized numbers. It will alarm one time
in each setting.
5.12.2 Cancel: Send SMS nomove+password to deactivate the movement alert.
Remark: This function will be out of effect after the unit moves outside the district.
5.13 Overspeed alert:
5.13.1 Set up: Send SMS speed+password+space+080 to the unit (suppose the speed is 80km/h),
and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the unit will send
SMS speed+080!+Geo-info to the authorized numbers. It will alarm one time in each setting.
5.13.2 Cancel: Send SMS nospeed+password to deactivate the overspeed alert
Remark: It is recommended that the speed alarm is set at not less than 50km/h. For below that
rate, it may cause the excursion of the GPS signal influenced by clounds etc.
5.14 IMEI checking:
9