Www.Visual-plus.Com ex9 wireless radio keypad ver 1.3 a company visual corporation plus.
Ex9 wireless radio keypad user manual v1.3 2 ex9-43b tx2a rx2 contents 1 product description ..................................................................................................................... 2 2 technical specifications ...............................................................
Ex9 wireless radio keypad user manual v1.3 3 dip switch 2 on: buzzer enabled off: buzzer disabled dip switch 1 on: backlighting enabled off: backlighting disabled power supply if battery is not used 12/24vac/dc 1 - 2 relay 1 (no) 3 - 4 relay 2 (no) 5 - 6 power supply 12/24vac/dc 7 antenna ground 8 a...
Ex9 wireless radio keypad user manual v1.3 4 step 2) send the user into rx2 reciever step 1) add new user in ex9-43b step 3) send tx2a code into rx2 reciever 5) programming entering the programming menu is done by the master code which is written on the sticker on back of the keypad. . Note: the key...
Ex9 wireless radio keypad user manual v1.3 5 master code assign transmission channel transmission duration setup delete one user delete all users the transmission time is set to 2 seconds by default. The transmission time setting applies to all users and all transmission channels other settings: cha...
Ex9 wireless radio keypad user manual v1.3 6 master code (1-8 digits) confirm by pressing b confirmation ok? Series of short beeps + orange led flashing end long beep + orange led fix on memorizing a new user code press 0 + enter the memory location of the user to memorize from 01 to 99 changing the...
Ex9 wireless radio keypad user manual v1.3 7 7) relay settings mode 1: immediate - the relay remains active until the radio signal persists mode 2: on/off (latch) - the relay remains active until a subsequent command is given or when the transmitter button is pressed once again mode 3: on time - the...
Ex9 wireless radio keypad user manual v1.3 8 8) total reset total reset of ex9-43b mote: in case of total reset all the users are deleted, the master code and all the settings are return factory default. Total reset of rx2 1. Cut the power supply of the receiver’s card 2. Keep pressed the tact switc...
