Xpr EX9 Manual - page 5
EX9 Wireless Radio Keypad User Manual v1.3
5
MASTER CODE
Assign transmission channel
Transmission duration setup
Delete one User
Delete ALL Users
The transmission time is set to 2 seconds by
default.
The transmission time setting applies to ALL
users and ALL transmission channels
Other settings:
Change Master Code
Enter the master code
Press B
Press 3
Enter the memory location of the
user to be enabled 01 to 99
Enter the channels to be
enabled from 1 to 10 (0)
Press A
Press B to exit
Enter the master code
Press B
Press 1
Enter the transmission time to
be enabled from 1s to 10s (0)
Press B to exit
Enter the master code
Press B
Press 9
Enter the memory location of the
user to be delated from 01 to 99
Press A
Press B to exit
Enter the master code
Press B
Press 8
Press 99
Press A
Press B to exit
NOTE: Before making any operation, take the sticker you find on
the back of the keypad and put it on the space here below (as
shown in the drawing) where it is written the master code set by
the factory.
Attach here the adhesive or write the master code
NOTE: In case of total reset of the device, the master code will
come to be the one indicated. The loss of this code will make the
keypad unusable.
Enter the MASTER code (1-8 digits)
Press B
Press 0
Enter the memory location of the master
00
Enter the new MASTER code from 1
to 8 figures long
Press A (only if the access code is
shorter that 8 figures)
Press B to exit
XXXX+A+(1)