Yale YDM4109 User Manual - page 10
Direction
18 / 19
How to Use
Repeated Operations
➞
1⃞
2⃞
3⃞
4⃞
5⃞
6⃞
➞
➞
➞
Press and lift up the Guide
Bar on the fingerprint cover.
You will see the fingerprint cover
being raised and start to open.
When the fingerprint cover is
completely open, the lamp will be on.
Start sweeping your fingerprint
through the sensor.
Complete your fingerprint
registration.
- You may register up to 20 fingerprints.
※Note that you may not register 20 fingerprints depending on the state of the previously registered fingerprints.
- Scan-type fingerprint modules do not recognize fingerprints with water or foreign materials and
set off alarm sounds.
- Make sure to register a PIN Code just in case you fail to register a fingerprint.
- Make sure to leave the door open when registering a PIN Code because you may accidentally lock a door
while trying to register or change a PIN Code the first time.
- If an error occurs during registration, the process reverts back the beginning. (entering fingerprint).
- If no more input is made for 20 seconds after registering at least 1 fingerprint, the registration will be complete.
- Duplicate fingerprints may be registered.
- Same fingerprints can be registered repeatedly.
Note
Fingerprint Guide
Safety Mode
Use Fingerprint
- It enables you to make separate registration and deletion, and open a door only when the
fingerprint number and the fingerprint match.
Note
➞
➞
➞
➞
➞
➞
➞
➞
To Register Fingerprint
》
To Open Door with Fingerprint
》
(3 times)
(01~20)
ⓐ
ⓑ
➞
➞
➞
➞
➞
➞
ⓒ
ⓓ
➞
Remove Fingerprint (Safety Mode)
To Delete All Fingerprints
》
To Delete Each Fingerprints
》
(01~20)
➞
➞
ⓐ Enter 2-digit fingerprint number to register.(01~20)
ⓑ After the operation lamp is on, sweep your fingerprint 3 times through the fingerprint
sensor according to the voice guide.
ⓒ Lift open the fingerprint cover and wait for the operation lamp to light on.
ⓓ Sweep the registered fingerprint through the fingerprint sensor in the front body.
Description