Yale YDM4109 User Manual - page 12
Open the battery cover and
take out a hex wrench.
Keep pressing the Safe Handle button.
Turn the set bolt found in next to
the handle to Close side.
Direction
22 / 23
Settings
Safe Handle Featurea
To Release Safe Handle Setting
》
The technology to prevent a forced attempt to drill a hole in the door and
unlock the Doorlock has been applied.
Auto Lock setting locks a door within 5 seconds after the door was closed.
Volume Setting Feature
It enables you adjust the volume of various sounds from the product.
Open the battery cover and
take out a hex wrench.
Turn the set bolt found in next to the
handle to Open side until the Safe Handle
button comes out.
To Set Safe Handle
》
Volume Setting
》
- Be careful that the set bolt won’t detach when modifying the Safe Handle Setting.
- Even when the operation sound is set as ‘Mute’, the error and alarm sounds will go off.
Note
- Even after a door was locked by the Auto Lock function, please check again if the door was completely locked.
- If a door is open when the Auto Lock is not properly operated, the Break-in alarm might go off.
- If the alarm goes off due to damage, fire, or break in, the numbers on the keypad will light up clockwise.
(It repeats the status for 30 minutes with alarm sound.)
Note
To set volume switch
The operation sound volumes are adjusted
according to the Volume Switch Setting.
(2 : Louder / 1: Lower / 0 : Mute )
Auto Lock Setting
Press the interior Auto/Manual Setting
button to keep the button up.
Auto / Manual Feature
The alarm sound continues for 30 minutes or until it is reset.
Alarm Feature
To Set Auto/Manual Feature
》
Manual Lock Setting
Press the interior Auto/Manual Setting
button to keep the button down.
Break-in:
When someone tries to Break-in by opening
a door when it was locked, the alarm will go off.
Break-in / Damage Alarm
》
Release Trespass/Damage Alarm
》
Damage:
When the front body was damaged due to forced
separation or drilling,the alarm will go off.
Method 1: Enter the registered Master PIN Code or User PIN Code
Method 2: Enter the registered fingerprint. Method 3:Press the interior button for 5 seconds.