Yamaha F150B Service Manual - Brkt
9-17
BRKT
Bracket unit
Disassembling the upper case
1.
Remove the drain bolt a.
2.
Remove the upper case bolts b and c,
and then remove the oil pan assembly
d.
3.
Remove the circlip e, and then remove
the bushing f.
Checking the drive shaft bushing
1.
Check the bushing. Replace if cracked or
worn.
Assembling the upper case
1.
Install the bushing a, and then install the
circlip b.
2.
Install the dowels e.
3.
Install the baffle plate f, and then
tighten baffle plate screws g to the spec-
ified torque.
4.
Install the rubber seal h into the joint
hole a of the upper case.
5.
Install a new rubber seal i and the rub-
ber seal j, and then install the oil pan
assembly k.
TIP:
Make sure to insert the tip of the cooling
water pipe l into the joint hole a of the
upper case.
6.
Install the oil pan bolts m and n, and
then tighten them to the specified
torques.
Bearing puller assembly g: 90890-06535
Stopper guide stand h: 90890-06538
Stopper guide plate i: 90890-06501
a
c
c
c
d
b
b
e
f
h
g
h
i
Needle bearing attachment c:
90890-06653
Driver rod L3 d: 90890-06652
a
b
a
c
d
c