Yamaha F150B Service Manual - page 87
3-10
Mounting the rigging grommet
0
1
2
3
4
5
6
7
8
9
10
A
10. Install the cable joint d to the pin c, and
secure it with the clip k.
TIP:
Pull the inner cable to avoid the free play
(backlash) of the cable, and install it to the
pin.
11. Tighten the locknut l to the specified
torque.
12. Check the shift cable for proper
operation.
Installing the throttle cable
1.
Fully screw in the cable joint a to the
throttle cable b.
2.
Open the clamp c of the throttle cable
holder d.
TIP:
Throttle cable position is adjustable by using
the throttle cable holder d.
3.
Pass the throttle cable b through the
grommet, fit the cable groove onto the
projection on the cable holder d for
installation.
4.
Contact the stopper a of the throttle cam
e to the crankcase boss b.
Locknut l: 5 N·m (0.5 kgf·m, 3.7 ft·lb)
e
j
f
c
d
l
k
b
a
d
c
b
d
b
a
b
e