Yamaha F50D Servise Manual - page 285

9-6

0

1

2

3

4

5

6

7

8

9

10

A

Checking the throttle cable and shift 

rod

1.

Check the throttle cable and shift rod for

smooth operation.

2.

Check the inner wire and outer wire of

the throttle cable. Replace if the outer

wire is bent or damaged, or the rubber

seals are damaged.

Assembling the tiller handle

1.

Install the throttle shaft 

1

  into the tiller

handle 

2

 so that the pin 

3

 of the throttle

shaft 

1

  is aligned with the mating sur-

face 

a

 of the tiller handle 

2

 in horizontal

position.

2.

Insert the throttle cable 

4

  into the gear

5

 until the inner cable 

b

 is winded with

the gear. Then fully pull the outer cable

c

 toward the cable end of the outboard

motor side.

3.

Turn the throttle shaft 

1

  clockwise to

wind the inner cable until the outer cable

c

 comes in contact with tiller handle.

4.

Tighten the outer cable 

c

  and locknut

d

.

1

2

3

3

2

a

4

b

c

b

c

5

1

c

c

d

Tiller handle (disassembling)