Yamaha F50D Servise Manual - page 71
3-14
0
1
2
3
4
5
6
7
8
9
10
A
å
H model
∫
R model
2.
Set the shift lever to the “N” position and
throttle grip to the fully-closed position.
(H model)
Set the remote control lever to the “N”
position and throttle lever to the fully-
closed position. (R model)
3.
Fully screw in the shift cable joint
5
to
the shift cable (rod)
6
.
4.
Check that the center of the bushing
a
is aligned with the alignment mark
b
on
the bracket.
5.
Adjust the shift cable joint
5
to the pin
c
of shift lever.
NOTICE:
The shift cable
joint must be screwed in a minimum
of 8.0 mm (0.31 in)
d
.
6.
Install the shift cable joint
5
to the pin
c
,
and then tighten the locknut
7
. Then
install the clip
8
.
TIP:
Pull the inner cable to avoid the free play
(backlash) of the cable, and install it to the
pin. (R model)
7.
Fully screw in the cable joint
9
to the
throttle cable
0
.
1
2
3
4
∫
5
6
a
b
5
7
8
5
d
c
9
0
Wiring harness connection / Control cable installation