Z-Wave RC-100 Operating Instructions Manual - page 10

10 

Operations 

The RC-100 remote controller can be set up as a Primary or 

Secondary Controller within a Z-Wave network. 

The RC-100 can control Z-Wave devices individually or as a group 

using Scene or Association. A single Z-Wave network can include 232 

nodes. If necessary, more than one network can be bridged to extend 

the number of nodes supported, although this is normally not needed in 

a residential environment. 

RC-100 control capability  

Total number of controllable 

End-point (EP) / device / sensor

128 items  

(listed on the “Device” and “Sensor” page)

Total number of thermostats 

6 thermostats  

(listed on the “Comfort” page) 

Total number of scenes 

12 scenes  (listed on the “Scene” page) 

Each Scene supports up to 

32 Z-Wave devices or End-point (EP) 

Network Setup (C1) 

Rediscover N.W. (C2) 

(Rediscover network) 

Delete Dead Node (C4) 

Listening Mode (C5) 

Re-scan Devices (C3) 

+ 

•  Press and hold cd keys simultaneously for 3 

seconds to enter Network Setup menu. 

•  Press BACK key to go back to previous page. 

•  Press and hold BACK key for 2 seconds to go 

back to root menu.  

Network 

Setup  

menu 

Create Sec. (C6) 

(Create secondary) 

Create Pri. (C7) 

(Create primary)