Z-Wave RC-100 Operating Instructions Manual - page 48

49 

⇓ 

3 

Select “Create a Sec.” 

then press 

 key. 

4 

Please make sure the 

target secondary 

controller is setup to 

receive information 

mode.  

(e.g. target secondary 

controller should entry 

the “Learning mode＂ 

if this is a another RC-

100. Please refer to the 

target controller user 

manual for more 

information) 

=> Target secondary 

controller will act as a 

secondary controller 

after this action. 

=> Original RC-100 

primary controller will 

still keep in a primary 

controller after this 

action. 

⇓ 

Create a Primary Controller 

(Transferring Only Network Information to a New Primary Controller) 

You can just transfer network information to another remote so that it 

will act as a new primary remote. This primary shift is done by 

following the steps below. 

Create a Sec. 

Copying… 

>>>> 

Create a Sec. 

Copying… 

>>>> 

OK 

Network Setup 

Rediscover N.W. 

> 

Delete Dead Node   > 

OK to Enter 

Re-scan Devices 

> 

Network Setup 

Listening Mode 

> 

OK to Enter 

Create a Sec. 

> 

Create a Pri  

>