Z-Wave RC-100 Operating Instructions Manual - Rc-100 Operations
6
RC-100 Operations
Welcome to the world of Z-Wave home automation, you can use your
RC-100 to control almost every Z- Wave certified products inside
your house. The following section will guide you through the set up
processes and operation procedures for your RC-100.
Please note that all Z-Wave devices, light switches, dimmers, shutter
switches, thermostat and secured door lock made from various vendors
are compatible with your RC-100 as long as they are Z-Wave
certified or carry the following Z-Wave logo:
(Please carefully read through the following sections of this user
manual and store for future reference.)
Before using the RC-100, please install the batteries:
• 4xAAA batteries are required for operation.
• Remove the battery cover on the back of your remote.
• Check the polarity of the batteries and the "+/-" marks inside the
battery compartment.
• Insert the batteries.
• Push the battery cover back in place.
L CAUTION (battery safety)
− Use new batteries of the recommended type and size only.
− Never mix used and new batteries together.
− To avoid chemical leaks, remove batteries from the remote
controller if you do not intend to use the remote for an
extended period of time.
− Dispose of used batteries properly; do not burn or bury them.