Z-Wave RC-100 Operating Instructions Manual - page 12

12 

4 

Press the program button 

on the target device. 

⇓ 

Note 1: If you can’t add your Z-Wave device, this device might have 

been included in another Z-Wave network. In this case, please delete 

this device following the steps in the [Deleting Device from the 

Network] section then add this device again. 

Note 2: This step can be skipped if the device is already included in the 

network. 

Note 3: In a Z-Wave network, only the primary controller or inclusion 

controller can add or include devices into its network. If RC-100 is 

configured as a secondary controller, it will report “Error” if users 

attempt to use RC-100 to add a device into its network. 

Note 4: If no ACK signal received for more than 60 seconds, the “Add 

Device” mode will exit automatically. 

Deleting Device from the Network 

Step 

Setup Key 

LCD Indication 

1 

Press and hold 

ef

keys simultaneously for 

3 seconds under the 

Home page. 

⇓ 

Home 

Device > 

Scene

> 

Comfort

> 

OK to Enter 

Add Device 

Press PROG on target 

>>>> 

Saving Data … 

Add Device 

Press PROG on target 

>>>> 

OK