ZBoost YX600 Series Installation Manual - page 12
4
Wi-Ex
YX600 Series Installation Guide
Power Requirements
The Base Unit can be plugged into a standard 2-prong 110 VAC receptacle
using the included power supply. The power supply consumes less than 10W
(less than 0.2A).
Warning:
The zBoost YX600
Series base unit MUST
only be used with the provided power adaptor.
Use of other power adaptors will void the
warranty and may damage the unit. Use of
other equipment is not FCC approved.
Installation Tools Needed
The following tools are needed to install zBoost:
• #2 Philips screwdriver
• Cellular phone operating in the band supported by your zBoost unit
• Drill (may be required for outdoor or attic antenna installations)
Installing Your zBoost
Installing the Signal Antenna
Choosing the best location for installation of the Signal Antenna provides the
best performance and the largest area of improved signal. Determine the
location which provides the strongest signal using the signal strength indicator
on your cell phone. Find the location which provides the most bars of signal
strength and locate the Signal Antenna at that location. This location will be
typically found on the roof.
Warning:
Avoid placing antenna near metal such as
wiring, A/C ducts, truss plates, etc.
When attaching the cable to the antenna, run
the cable straight down from the antenna.
Avoid draping the coax near the antenna.
Figure 3
Figure 4
YX023-PCS Antenna
YX021-CEL Antenna
for YX600-PCS
for YX600-CEL