ZBoost YX600 Series Installation Manual - page 5
Wi-Ex
iii
YX600 Series Installation Guide
Outdoor Installation of the Directional Signal Antenna
Grounding the
Directional Signal
Antenna
The Directional Signal Antenna assembly must be properly grounded when it
is installed outdoors. This will help protect the customer's property and the
Base Unit against lightning strikes during a lightning storm.
The installation must be in accordance with Article 810 of the National Electric
Code (NEC). A listed antenna discharge unit must be provided for the lead-in
coaxial cable per NEC article 8.10.20 or the shield of the coaxial cable must be
permanently and effectively grounded in accordance with NEC article 8.10.21.
Securing Cable with
a Drip Loop
When you install the Directional Signal Antenna, create a drip loop with the
coaxial cable at the point where the cable enters the building through an
outside wall. This can be done by twisting and securing the cable into a loop
near the entry point. This will help prevent moisture from gathering at entry
point and leaking into the building.
Pre-Installation
Guidelines
Outdoor installation is preferred when a home is In an area of weak outdoor
signal area (generally 1 to 2 bars as indicated on the cell phone).
Avoid any drilling or nailing directly into the roof. This could allow water to leak
into your home and cause damage.
Choosing to mount the antenna into fascia will not compromise your roof and
places the antenna up high