ZBoost YX600 Series Installation Manual - page 3

Wi-Ex 

i

YX600 Series Installation Guide 

Read First Before Installing the YX600 Series  

Before unpacking this box, verify that your phone operates on the frequency 

band supported by this product.  

- 

The YX600-CEL will enhance your in-building coverage for local 

provider networks operating at the 800MHz (Cellular) frequency.   

- 

The YX600-PCS will enhance your in-building coverage for local 

provider networks operating at the 1900MHz (PCS) frequency. 

(NOTE) The YX600 Series is not compatible with iDEN, Nextel, SMR or ESMR 

frequency services.  

To verify that your phone will work in conjunction with the model purchased, 

please follow these four simple steps: 

1)  Unpack the Base Unit and the Base Unit power supply only. 

2)  Connect the power supply to the Base Unit and plug it into an outlet. All of 

the lights will flash for several seconds and then the Power light should be 

solid green. 

3)  While standing about 1 foot away from the Base Unit, turn on your cell phone 

or make a call.  If the Signal light begins flashing green, you can proceed 

with the installation of the system.  If it flashes red, move your phone further 

away from the Base Unit (typical for GSM) and retry. 

4)  If the Signal light does not flash green, try to place another call with your cell 

phone directly touching the unit (typical for CDMA cell phones).  If the Signal 

light still does not flash green, your cell phone may not be compatible with 

the model purchased.  Contact Wi-Ex technical support at 1-800-871-1612 

for further assistance. 

Note: 

The YX600 Series is fully automatic.  The Install, Signal, and 

Power lights on the Base Unit are not buttons.  There are no 

buttons to press on the Base Unit.