ZBoost YX600 Series Installation Manual - page 15

7 

Wi-Ex 

YX600 Series Installation Guide 

Wall Mounting the Base Unit 

The Base Unit can also be easily mounted on a wall using the included mounting bracket hardware.  The 

Base Unit should be a minimum distance of 4-5 feet off from the floor so there is clearance for the Base 

Unit antenna extension. 

Perform the following steps to mount the Base Unit on a wall: 

1)  Remove the mounting bracket from the Base Unit by slightly spreading the tabs on the gray mounting 

bracket. 

2)  Fasten the mounting bracket to the wall using the self-tapping wall/ceiling anchors 

3)  Attach the coaxial cable from the Signal Antenna to the Base Unit. 

4)  Attach the antenna to the Base Unit. 

5)  Attach the power supply to the Base Unit and plug the power supply into an outlet.  See the 

Troubleshooting section if a Red light illuminates. 

6)  Snap the Base Unit into the mounting bracket.