Zebra MZ series Installation And User Manual
Important Charger and Battery Safety Information
Keep this guide available. It contains important safety and operating information.
Battery Safety
Caution • Short Circuits
Avoid accidental short circuiting of any battery. Allowing battery terminals to contact
conductive material will create a short circuit which could cause burns and other injuries or
could start a fire.
Caution • Don’t Use Damaged Batteries
Never attempt to charge a battery that is visibly damaged or is emitting odors.
Caution • Always Use Zebra Batteries
Use of any batteries not approved specifically for use with this charger could cause damage
to the battery or the charger and will void the warranty.
Important • Observe Battery Safety Precautions
Always observe the safety precautions in the Lithium-ion Technical Bulletin included with
each Battery Pack.
Important • Battery Disposal
Always dispose of used batteries in accordance with local regulations. Placing used
batteries into the trash or the municipal waste stream may be illegal in your area.
Insulate battery contacts with a piece of tape prior to disposal.
Charger Safety
Caution • Use the Correct Zebra Charger
Only charge the supported battery pack types designated for use with this charger. Use of
any battery charger not approved specifically by Zebra for use with its batteries could cause
damage to the battery pack or the printer and will void any equipment warranty.
Caution • Correct Voltage
Ensure that the Battery Charger is configured for the A.C. voltage used in your area and you
are using the correct A.C. power cord and/or power supply for the intended country of use.
Use the charger with the supplied power supply only, which must be plugged into an earth
grounded outlet.
Important • Charger Location
Use care in locating the Charger. Do not place it in locations where liquids or metallic
objects may be dropped into the charger. Never locate the charger near any source of
combustion.
Ensure that the Charger is plugged into a power source that won’t accidentally be turned off
if you will be charging batteries overnight.
Important • Indoor Use Only
This charger is intended for indoor use only.
Important • Charger Maintenance
Clean only with a dry or slightly damp, lint free cloth.
Never operate a charger that has been damaged in any way.
Do not disassemble the battery packs or the charger.
There are no user servicable components inside
MZ Series Power Station Installation and
User Guide
1
MZ Power Station Installation and User Guide