Zebra MZ series Installation And User Manual - page 3
Plug the power supply output cable into the Power Station.
You may elect to secure the power supply to the back of the
Power station using the supplied Velcro
®
straps at this time.
Ensure the power cord supplied with your Power Station
is the correct one for use in your locality. Plug the AC power
cord into the power supply and into an AC receptacle. The in-
dicator on the power supply should light up.
The Power Station should be situated to avoid the possibility
of interfering with operator’s normal activities, and should be
plugged into an AC outlet that will not be accidently shut off if
you are planning twenty-four hour charging of batteries.
Figure 2: Power Supply Installation
3
MZ Power Station Installation and User Guide
Power Supply p/n AT18138-2
Input 100-240 VAC@1.2A
Output: 12 VDC@4.2 A
Holding
straps
AC Receptacle
AC Power Cord
Power Supply
Output Cable