Zebra MZ series Installation And User Manual - page 2
Charger Specifications
The power supply is compatible with all common AC supply
voltages. AC voltage setting is automatic.
Power Supply
Specifications
Input
100-240 VAC @ 1.2 AMPS
Max., 50-60 Hz
Output
12.0 VDC @ 4.2 AMPS Max.
Power Supply
Operating
Temperature
During
Charge
0
o
C to 35
o
C
20% - 80% relative humidity
In Storage
-10
o
C to 70
o
C
10% - 90% relative humidity
Installation
The MZ Series Power Station’s power supply may be se-
cured to the back of the Power Station with the supplied
straps, or may be located a distance from the main charger
module. The Power Station also has provisions to allow hang-
ing from a wall. (Refer to Figure 3.) The power supply cannot
be secured to the back of the Power Station when using this
mounting method.
You should leave a 1.75 in [44.5mm] minimum space above the printer
to allow its insertion and removal if you are installing the Power
Station under an overhang.
2
MZ Power Station Installation and User Guide
Figure 1: Mounting Dimensions
19.62” [498.35 mm]
5.31”
[134.9 mm]
(Includes depth of power
supply when secured to
the Power Station)
4.75”
[120.7 mm]
3.65” [92.7 mm]